Replacing Atf And Filter

Approx. 8.0 liters approx. 6.0 liters ATF and filter must be replaced every 30,000 miles. ATF not filter should be replaced more often, if car is subjected to severe operating conditions trailer hauling, etc. . Car must be on level surface when replacing ATF. Also have transmission at operating temperature and engine stopped. Unscrew oil drain plug in oil pan and let ATF drain, Turn crankshaft until converter drain plug can be seen and removed. Remove transmission oil pan and replace oil...

Removing And Installing Rear Wheel Brake Pads

Remove locks with wire guide plate on If brake pads can be re-used, mark them when removing. Pads must not be moved from outside to inside and vice versa or from right to left wheel. This would cause uneven braking effect. 1. Pull sensor for brake pad wear indicator out of pad plate. 4. Remove inner brake pad with a pulling hook or impact puller. 1. Replace brake pads, which show deep cracks, have become loose from back plate or are covered with oil. In this case also replace all...

Checking And Adjusting Parking Brake

The parking brake has to be adjusted, if the parking brake lever can be easily pulled up more than 2 notches without any braking effect. S. Pull up parking brake lever 2 notches and turn adjusting nut that the wheels can just be turned by hand with 4 notches the wheels must be shopped . 1. Jack up car and remove rear wheels. 2. Release parking brake and push back rear wheel disc brake pads until the discs can be turned easily. 3. Loosen adjusting nut on spreaaer lock until cable is witnout...

Checking Fuel Pressure

Pressure Tester P378

Unscrew capped nut on distributor injection tube. specifications, clamp return hose slowly with a clamp at rear next to the fuel level transmitter. Be careful that sealing ball does not fall out when taking off the capped nut. Catch escaping fuel. 2. Connect pressure tester P 378 or VW 1318 and P 378 c. if pressure is less than 4 bar, check fuel filter or, if applicable, replace fuel pump. 5. If engine cannot be operated, pull off relay XX and bridge terminals 30 and 87. Fuel pump should...

Correcting Co Adjustment On Air Volume Sensor

If CO level deviates from the specified value, remove plug in bore affording access to the CO adjusting screw after removal of the air sensor. 2. Drill hole in plug with a 2 mm dia. drill up to stop on steel insert . 3. Pull out plug with a lefthand spiral drill size no. 2 . 3. Install a new plug in bore affording access to CO adjusting screw after finishing adjustments. Press in plug flush. 2. Adjust CO and engine idle speed. Turn CO adjusting screw accordingly with Special Tool 9230. Turned...