Changing Engine Oil And Engine Oil Filter

Requirement:

Engine at operating temperature. 1. Loosen and remove oil filter cap.

3. Loosen oil filter with a standard strap wrench, or US 4462.

2. Remove oil drain plug from oil pan and drain engine oil.

4. Clean drain plug. Replace seal. Tighten drain plug to 50 Nm (36 ftlb).

5. Lubricate gasket on oil filter slightly, install by hand until gasket contacts surface and then tighten one more turn.

6. Add engine oil, run engine to operating temperature and check for leaks.

7. Check oil level on stopped engine.

2. Remove oil drain plug from oil pan and drain engine oil.

0 0

Post a comment