Can onlyitrrV

renewing steering arms

10 mm

Height adjustment settings apply to new cars. After cars have been driven for a period the height may be max. 10 mm less, in other words the downward tolerance can vary by 10 mm more. However, this must then apply to both axles.

"Tie caster angle value of 4* + 1* can be adopted retrospectively on cars back to the 1986 model year inclusive (from introduction of vertical ball joint at front axle subframe pivot / refer to Page 40 -19).

The caster tolerance range on the measuring chart should be modified if necessary. The printed measuring chart will not be amended until a new issue is printed.

0 0

Post a comment