If vehicles have aluminium joint carriers

always turn the caster eccentric from small values towards large caster values, i.e. if the caster value is too high, first turn the eccentric back completely and then adjust to the correct value. This guarantees that the camber and caster values are always maintained, even under extreme operating conditions. If it is not possible to achieve the prescribed caster value, adjust the other side to the higher value if necessary (up to 4 degrees 30' is acceptable).

No.

for aluminium

for steel

joint carrier

joint carrier

1

Caster eccentric

Camber

eccentric

2

Camber eccentric

Caster

eccentric

Adjusting toe

Preparation: Center steering gear with Special Tool 9116. If the steering wheel is offset, relocate at the best value. Then remove Special Tool 9116.

0 0

Post a comment