Note

The asymmetric hump changes its cross-section across the circumference. The following points must therefore be observed when fitting or removing a tire.

1013-

When starting to fit the second bead, the assembly arm should be located opposite the valve. Then place the second bead as flat as possible onto the wheel, guide it across the assembly head and tie it down with Special Tool 9539, keeping it offset by approx. 90 to 120 deg.

While performing the turning motion and fitting the second bead, use a second tire lever and Special Tool 9539 to locate the tire bead in the drop center.

- To facilitate assembly, position the additional tire lever below the hump.

1015 -44

1016-44

1015 -44

1016-44

0 0

Post a comment