No Operation

Instructions

Close mixing cartridge

Pull injector nozzle (H7) out of mixing cartridge (H3) and close mixing cartridge with screw-on cap.

19 Screw mixing rod into mixing cartridge

Screw mixing rod (G) manually into internal thread of mixing disc in the mixing cartridge (H3). Clamp other end of mixing rod into a drill chuck. Fit the drill into a suitable clamping device.

20 Mix component A and component B

Switch on drill (900 to 1200 rpm) and rotate mixing cartridge 25 times from stop to stop. Perform ail 25 double strokes fairly rapidly.

21 Engage mixing disc into piston

Pull back mixing cartridge until a rattling sensation is felt.

Switch off drill and screw mixing rod out of mixing cartridge.

The mixing disc will then engage into the piston of the mixing cartridge.

22 Place mixing cartridge into bonding gun

Insert mixing cartridge with mixed 2-pack windshield adhesive into bonding gun.

Screw application nozzle (H8) onto mixing cartridge-

Was this article helpful?

0 0

Post a comment