Conversion

Strip plug leads

Fit threaded sleeve

Shorten insulation of plug lead (A) by approx. 6.8 mm. The dimension of 6.8 mm can be checked by placing the lead against the corresponding spot marked on the stop pliers (F).

Place threaded sleeve (C) up to the stop onto the plug lead. Place plug lead along with threaded sleeve into stop pliers. Connect wire to threaded sleeve by pressing the stop pliers until they disengage by themselves. Fit strain relief clamp by crimping the threaded sleeve in the stop pliers, making sure the pliers profile is flush with the end of the threaded sleeve on the plug lead side.

0 0

Post a comment