Installation

The following points must be observed for installation.

a. Plug multiple connector onto air flow sensor.

b. Connect wiring harness with transmission socket. To do this, carefully insert the connector in the socket (fits only in one position) and lock by turning the bayonet lock to the right.

387-38

2. Make sure that the inner rubber seals of the plug-in connections are fitted properly.

3. Make sure that the profile seals between the engine paneling and body are properly fitted.

4. When tightening the oil line in the rear right wheel house, make sure that the oil line does not turn as well and repeat tightening if necessary.

387-38

1. Before final positioning of the engine-trans-mission assembly in the installation position, the following connections must be made:

0 0

Post a comment