Removing and Installing Starter

Removing

1. Disconnect battery ground lead.

2. Remove engine splash guard.

Procedures - Left Side

1. Unscrew and disconnect drive shaft on flange of differential.

2. Remove heater hose.

3. Remove holder for engine splash guard.

4. Unscrew and lay clutch slave cylinder aside with the connected hose (use a 1/4 inch ratchet).

5. Unscrew upper starter hexagon socket nut with a 3/8 inch ratchet and 10 mm INHEX

Procedures - Right Side

1. Unscrew and disconnect drive shaft on flange of differential.

2. Unscrew upper holder for engine splash guard.

3. Remove heater hose.

4. Disconnect term. 30 and 50 leads.

5. Disconnect ground strap between the body and lower starter mounting point and remove starter.

Installing

1. Mount term. 30 and 50 leads with sufficient spacing between each other. Install protective cap on terminal 30.

2. When mounting the transmission end drive shaft flange, make sure that bearing surfaces are absolutely clean and without grease. Only lubricate bolt threads with a minimum amount of Optimoly HT (copper grease).

0 0

Post a comment