Removing dismantling and assembling fuel tank

Removing, dismantling and assembling fuel tank

No.

Designation

Removal

Installation

1

Hexagon head bolt M 8 x 40

1

2

Support plate

1

3

Restraining strap

1

4

Protective cover

1

5

Hose clamp 26 x 12

1

5a

Molded hose

1

6

Hose clamp 26 x 9

1

7

Hose clamp 19x9

1

8

Suction hose

1

Pinch with hose clip

9

Hose clamp 15x9

1

10

Hose 8 x 3.5, length 870 mm

1

11

Screw with washer assy M 6 x 22

3

12

Spacer (plastic)

3

13

Hose clamp 26 x 9

4

14

Hose, length 80 mm

2

15

Expansion tank

1

16

Hose clamp 14x9

2

9.5 x 15.5, length 170 mm

1

18

Shutoff valve

1

19

Grommet

1

20

Molded hose

1

21

Electronics unit

1

22

Sender unit

1

Tighten with wrench socket 9277 (Special Tool). Tightening torque 30 Nm (22 ftlb)

23

Sealing ring

1

Always replace when reassembling; coat lightly with acid-proof grease

No.

Designation

Qty.

Removal

Note:

Installation

24

Fuel filter

1

Clean, coat threads lightly with Optimoly TA, tightening torque 25 Nm (18 ftlb)

25

Flat gasket

1

Always to be replaced

26

Hose clamp 16x9

1

27

Return hose

1

28

Tank lock

1

29

Seal

1

Check, replace if required

30

Circlip 37 x 2

1

31

Support pad

1

32

Filler neck

1

Assembly notes Removing and installing fuel tank

Removing

1. The fuel contents may be drawn off via the fuel level sender hole. For this purpose, the fuel tank must not be filled by more than 3/4.

2. Disconnect battery.

Installing

Before locating in its final assembly position, the bleeder hose must be fixed with hose band clamps.

2. Disconnect battery.

3. Pinch off fuel hose using hose clips. Disconnect hose clamp from bleeder hose and pull off from Tecalan line.

743-15

3. Pinch off fuel hose using hose clips. Disconnect hose clamp from bleeder hose and pull off from Tecalan line.

743-15

911 Carrera 4 Fuel System, Electronic Injection

0 0

Post a comment