Control module housing removing and installing

— Remove passenger seat to gain access to heater controls and parking brake handle assembly.

— Remove access panel from right side of heater control housing.

^ Disconnect heater valve servo control rod (arrow) from lever.

— Remove heater control housing trim screws from floor.

— Remove rubber sleeve covering parking brake lever.


^ Lift control module housing up and turn over.

• Lift rug behind and under housing.

• Disconnect electrical harness connectors (arrows).

— With all wiring harnesses disconnected remove control module housing.

^ If replacing servo control rod, set length (A) to specification below.

Servo Control Rod



I l lj.lipijpjjjl

Was this article helpful?

0 0
Porsche Classic Models

Porsche Classic Models

The History of Porsche Cars through its generational changes. A must have ebook for any Porsche fanatic, this ebook is a reference book for Porsche enthusiasts. Discover all there is to know about the greatest Porsches ever made. All models are fully described and illustrated providing a definitive production history plus an accurate guide to original specs and equipment.

Get My Free Ebook

Post a comment