4. Peel off protective paper parallel to label lettering and, if applicable, remove bubbles by puncturing with a pin and pressing smooth.

1. Peel off beige paper backing from label. Position label at right visible joint of tail panel and align bottom edge of label to be parallel with edge of body.

2. As long as the label has not been pressed on hard it can be corrected by lifting off again. Make sure that shaded areas are pressed on without folds.

3. First rub label from center toward outer edges with light pressure and then rub hard with a plastic putty spreader carefully, avoiding any bubbles.

Was this article helpful?

0 0

Post a comment