Info

CELETTE ALIGNMENT/ASSEMBLY STAND

The set of attachments ENS 224. 300 was developed for pulling and straightening work on bodies.

This set of attachments consists of basic equipment with which all check points of the body can be tested. This set also has attachments for simple body repairs.

For cars with a modified rear axle as from 1978 models all new rear axle take-up attachments are included in straightening attachment kit ENS 224. 309.

Straightening attachment kit ENS 224. 308 will be required in addition for cars with a different front axle as from 1979 models.

Spring strut domes and auxiliary carrier take-ups must be set at zero. Maximum tolerances in length are ± 3 mm (1/8 in.), but the maximum difference between left and right is 4 mm (5/32 in.).

The maximum height tolerance for all attachment points is 4 mm (5/32 in.). The body must be able to be bolted to the straightening attachments at all check points.

Celette alignment/assembly stand with basic equipment

Figure shows additional attachments for simple repairs. Installation requires removal of torsion plate covers and outer rubber mounts. Rear axle, transmission and central tube do not have to be disassembled.

Cross member and front supports

0 0

Post a comment