Removing And Installing Popup Headlight Motor

3. Before installation of the motor, disconnect battery ground strap, turn off light switch, connect plugs to motor and connect battery ground strap again.

2. Unscrew nut on end of shaft, remove three hexagon head screws and take out motor.

1. Disconnect plugs on pop-up headlight motor.

2. Unscrew nut on end of shaft, remove three hexagon head screws and take out motor.

3. Before installation of the motor, disconnect battery ground strap, turn off light switch, connect plugs to motor and connect battery ground strap again.

The motor will run to its starting position and switch off automatically because it is not already at this position. Do not turn the motor and install it with closed headlights.

4. Turn on lights. The pop-up headlights must open completely. If not detach linkage on motor again and mount in proper position.

When the headlights are open completely the rubber pads must rest on the metal sheet, so that the head-lights are fixed in their final position. Adjust the stops if necessary.

0 0

Post a comment