Removing And Installing Needle Bearing

Remov ing

Note

Needle bearing can be replaced without removal of engine. Clutch must be removed first. See Repair Manual - Group 30.

Pull out needle bearing with Special Tool 10-202.

13-12 Removing and Installing Flywheel Replacing Starter Ring Gear

Version II

Version I

Pull out bearing sleeve with US 1088.

Version II

Pull out bearing sleeve with M 12 x 65 hexagon head bolt.

Installing

Drive in needle bearing up to stop with Special Tool 9124.

For version II drive in seal up to stop with Special Tool 9123.

Grease capacity:

Use about 3 grams of lithium grease NLGI grade number 3 such as, for example, "Shell cyprina grease 3 ". Unsuitable greases would damage needle bearings.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment