Note

After tightening the pressure plate, center the intermediate ring between the pressure plate and flywheel. There should be a gap of 0,7 to 1.0 mm (see sketch) between bracket and stop.

3. Install throw-out bearing sleeve.

4. Position end of release lever against ball pin, press lever back and down until it snaps into place.

5. Tighten clamping sleeve. Install lower bell housing and slave cylinder.

1 — Intermediate ring

2 — Intermediate ring stop

3 — Sliding mount for bracket

6 — Bracket resting against stop A — Throw-out bearing side

Was this article helpful?

0 0
Porsche Classic Models

Porsche Classic Models

The History of Porsche Cars through its generational changes. A must have ebook for any Porsche fanatic, this ebook is a reference book for Porsche enthusiasts. Discover all there is to know about the greatest Porsches ever made. All models are fully described and illustrated providing a definitive production history plus an accurate guide to original specs and equipment.

Get My Free Ebook


Post a comment