Info

Removing Controls and Checking Function after Removal

1. Remove door trim panel.

Note

If still disconnected, connect multiple pin plug of wire harness for passenger" s door.

If a test lamp is used to check the plugs, it could happen that the control will be switched on (power flow via test lamp).

5. Remove lock cover.

5. Remove lock cover.

2. Pull off plugs on control and check plug connections.

6. Remove control.

1 = green/black

2 = yellow

3. There should be battery voltage between lines of red/white term, 4 and brown term. 3 (ignition turned off).

With the opposite side in unlocked position, the following voltage conditions should be prevailling at term, 1 and 2:

Wire, yellow term. 2 - with voltage. Wire, green/black term. 1 - without voltage.

Voltage should be opposite when in locked position.

If voltage is not as described, replace control for opposite side or check wire harness.

6. Remove control.

7. Disconnect transmitting linkage at winder.

7. Disconnect transmitting linkage at winder.

I. Install control.

Note

Mount control with the original M 6 x 8 bolts. Longer bolts would impair clearance of winder.

8. Connect plugs on removed control (ignition turned off).

3. New controls are supplied in locked position; the winder faces right in installed position.

2. Pull up inner door recess seal above the control, so that position of winder to transmitting linkage can be observed from above after installation of control.

3. New controls are supplied in locked position; the winder faces right in installed position.

Turn winder clockwise from 1 to 2 by hand. Control should switch on in position 2 and continue turning to 3.

Turn winder further by hand about 45 (3 to 4). The control should turn further to initial point 1.

Replace control, if function is not correct.

Winder must turn easily from stop to stop. Replace the control when movement is hard,

8. Connect plugs on removed control (ignition turned off).

6. Unlock door and open the door lock by operating the inside or outside handle.

7. Check function of locks on both doors prior to final assembly.

Locking buttons must be pushed in by at least 3 mm before the controls run.

Note

Doors can only be locked when both doors are closed. If one door is open when locking the doors, the locking system will return to open state.

4. To adjust, move lock mechanism of opened door to "closed" position and push in locking button.

5. Hold winder of control in position 1 against stop.

Ball socket on linkage must be aligned with ball head of winder.

If ball socket and ball head are not aligned, correct position of control in mounting bores or file slots, if necessary.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment