Removing And Installing Door Window And Regulator

Removing

1. Adjust door window (door trim panel removed), that slides on guide tube are accessible.

Porsche 928 Tube

2. Now unscrew slides and detach window lifting tube at top.

3. Pull off inside window recess seal, then tilt and remove door window glass.

1985 Porsche 911 Window Stop Adjustment

Note

Unscrew or detach guides (arrow) in upper door recess to improve accessibility (see figure to right).

4. Unscrew window regulator from inside door panel (arrows), pull off electric wire plugs from motor and remove window regulator through large opening in inside door panel.

Porsche 928 Window Motor

Installing

1. Place door window glass in door.

2. Install guides (position inward).

3. Guide in window regulator, connect it to lifting rail and bolt to inside door panel (arrows). Connect power supply plug.

Porsche Window Regulator

Stop wedges must be installed only with countersunk metal screws.

3. Guide in window regulator, connect it to lifting rail and bolt to inside door panel (arrows). Connect power supply plug.

4. Install window recess seals, window guides and ornamental frame.

Stop wedges must be installed only with countersunk metal screws.

5. Set guide tube with mounted slides in center position and bolt to lifting rail.

Ornamental Window Frames

Note

Use a plastic hammer to install ornamental frame on edge of window opening. Coat rubber parts with petroleum, to facilitate pressing them into ornamental frame grooves. In the past a Iinei was mounted in the front curve with pop rivets, in the outer holes of which the ornamental strip corner was installed. The new corners are mounted with clips.

Note

Make sure that wire harness is routed to outside mirror, so that it will not come in contact with glass.

Lubricate window lifting rails and guide tube with a multi-purpose grease.

6. Run up window until it is completely in window frame, adjusting guide tube mountings if necessary.

Window Regulator Replacement Porsche

7. Loosen both slides to relieve pressure on window glass and then tighten.

8, Lower window and measure distance to guide rail (5 to 6 mm) and adjust lower slide, that window glass runs in center of window frame. If necessary, loosen slides and tighten again after removing stress from window glass.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Responses

Post a comment