Removing And Installing Outside Mirror

1. Pry off clips on mirror glass with a putty knife on backplate and disconnect contact plugs on glass carefully.

Porsche 944 Mirror Removal

4, Unscrew fillister head screw on mirror base so that mirror can be removed with the liner.

2. Unscrew 3 screws through holes in backplatE, take off foam rubber part and pull off wire plugs.

Porsche 928 Mirror

5. Install in reverse order.

1. Pry off clips on mirror glass with a putty knife on backplate and disconnect contact plugs on glass carefully.

2. Unscrew 3 screws through holes in backplatE, take off foam rubber part and pull off wire plugs.

3. Note wire positions in receptacle by colors. Press in locks on each wire plug separately with an extraction toot and pull out wires.

4, Unscrew fillister head screw on mirror base so that mirror can be removed with the liner.

5. Install in reverse order.

6. If wire harness in door has to be removed, take off inside door trim panel and take harness out of holders.

How Wire Holding Contacts

8. When installing, make sure wire harness is secured with the provided holders and cannot contact the door window glass.

7, Disconnect plug underneath instrument panel, press out wires on outside door mirror with an extraction toot and pull out wire harness.

Toot Extracting Instrument

SERVICE INSTALLING OUTSIDE MIRROR ON PASSENGER'S DOOR

1. Remove inside trim panels on doors. Pull off door plastic sheets partially. Remove outside mirror and wire harness on driver's door.

2. Paint mirror set to match body color of car.

3. Insert guide tube with spring and centering plates and torque to 15 + 3 Nm {130 + 2jn.lb) with a multiple socket wrench.

Standard Socket Wrench Inside DimensionsHole Liner Door Pull

4, Mark location of hole on door outside panel according to specified dimensions, punch mark and drill 16 mm and 22 mm dia. holes with a standard compass saw. Cut out and file opening with suitable tools.

Caution!

Do not damage door reinforcement.

6. If necessary, align door reinforcement on door outside panel. Fit in mirror base, correcting drilled holes if necessary. Make sure of proper fit.

7. Install new wire harnesses from inside of door to outside and pull into mirrors. Mount mirrors and liners on doors with fillister head screws, which are torqued to 5.6 Nm (4 ftlb).

Rear view:

Pin Wire Side Access PlugPorsche 928 Side Mirror Modified

8. Wire harnesses must be secured in holders provided in a manner to prevent contact with the door window.

Right multiple pin plug (passenger's side)

Rear view:

Terminal 66 = blue Terminal 7 = white Terminal 8 = black Terminal 9 = gray/green Terminal 16 = brown

Was this article helpful?

+1 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Responses

Post a comment