Removing And Installing Singledisk Clutch


1.Detach ground lead from battery.

2.Remove complete lower engine guard.

3.Unbolt clutch actuating cylinder, disconnect clutch hose holder from oil pan and allow cylinder to dangle with line connected.


Never depress the clutch with actuating cylinder disconnected.

4.Unbolt starter motor, withdraw and leave on bracket.

5.Unbolt exhaust flanges on left and right manifolds and detach air injector.

6.Remove cover from clutch housing.

7.Remove clamping sleeve cap screws and push sleeve back along central shaft II. If long clamping sleeve is fitted, remove plug in central tube to permit removal of the rear screw.

8.Remove securing screws for guide tube and push guide tube toward flywheel.

9.Disengage release lever from ball joint by pressing lever down toward flywheel.

10.Fabricate three sheet-metal angles (2 mm thick), if no angles are installed.

Porsche Classic Models

Porsche Classic Models

The History of Porsche Cars through its generational changes. A must have ebook for any Porsche fanatic, this ebook is a reference book for Porsche enthusiasts. Discover all there is to know about the greatest Porsches ever made. All models are fully described and illustrated providing a definitive production history plus an accurate guide to original specs and equipment.

Get My Free Ebook

Post a comment