1

Since the old version doors still have the old mounting point, old or new door lock cylinders may be installed by filing the door mounting point.

A 6.4 mm dia. washer, a 6 mm dia. lock washer and a M 6 x 8 mm fillister head screw are required to mount the door lock cylinder.

Doors with the new mounting point and new door lock cylinder require a spacer, 6.4 mm dia. washer, and a M 6 x 18 mm fillister head screw.

File mounting point if necessary. Installation of the door lock cylinder requires use of a 6.4 mm dia. washer, 6 mm dia. lock washer and a M 6 x 8 mm fillister head screw.

The following procedures are required to install an old door lock cylinder in doors with the new mounting point.

Fit in door lock cylinder. Check distance between mounting point and door lock cylinder. Change mounting point with the locally made tool in such a manner, that door lock cylinder and mounting point are in same level.

1. Open sun roof lid to rear end position. Unsrew sun roof liner mounting screws.

Porsche 928 Front Ends

4. Close sun roof lid but for gap of approx. 10 mm. Lift front end of sun roof lid slightly, push back sun roof lid out of guides and lift off toward front.

REMOVING AND INSTALLING POWER SUN ROOF (WITHOUT REMOVING GATES)

1. Open sun roof lid to rear end position. Unsrew sun roof liner mounting screws.

2. Pull out sun roof liner toward front.

4. Close sun roof lid but for gap of approx. 10 mm. Lift front end of sun roof lid slightly, push back sun roof lid out of guides and lift off toward front.

3. Detach front guide and gates by loosening screws on sun roof.

1. Check attachments before installing the sun roof lid (lid seals, gates and guides). Replace parts, if necessary.

Proceed as follows, if sun roof lid had been disconnected on the gate mounting screws or the gates had been replaced.

Installation is in reverse sequence.

2. Adjust sun roof liner that trim runs over roof frame without friction.

1. Correct the distance between gates, if necessary between brackets and gates, with washers.

60 -2 Removing and Installing Power Sun Roof

2. After closing the sun roof lid, the rear end of the lid must be in same plane as the roof panel. Height can be corrected with the rear gate screws.

3. The lid's front edge can be adjusted to the roof plane with the recessed adjusting screws, whereby the mounting screws must be loosened first.

REMOVING AND INSTALLING DRIVE MOTOR AND GEARBOX FOR SUN ROOF Removing

1. Pull down rear end of cover slightly, 3. Check rubber/metal mounts, replacing disconnect spring wire and take off if necessary, cover toward rear.

1984 Porsche 928 Wiring Diagram

2. Disconnect wire plugs. Unscrew mounting nuts and screw. Take off motor and gearbox.

Installing

Check motor, gearbox and clutch for damage before installing, replacing if necessary. Installation is in reverse sequence.

Removing and Installing Drive Motor and Gearbox for Sun Roof

1, Open sun roof lid and unscrew deflector opener mounting screws.

Wiring Diagram 1984 928

2. Unclip locks on pins.

Was this article helpful?

0 0
Porsche Classic Models

Porsche Classic Models

The History of Porsche Cars through its generational changes. A must have ebook for any Porsche fanatic, this ebook is a reference book for Porsche enthusiasts. Discover all there is to know about the greatest Porsches ever made. All models are fully described and illustrated providing a definitive production history plus an accurate guide to original specs and equipment.

Get My Free Ebook


Post a comment