Note

— Rubber mounts and grommets on speed sensors are connected with wire covers (n precise position.

— Take speed sensors out of protective packaging only briefly before installation (loss of permanent magnetism).

— (Vlake sure that there are no foreign metal pnrticles (burrs) on magnetic edge of speed sensor before installing.

3. Route wires correctly (insert rubber grommets and clip rubber mount in holder} Install exhaust shield. Connect wire plug and press mto holder. Mount front wheel and intake hose.

4. Check function with ABS tester.

Rear Axle

Removing

1. Take off wheel.

1. Coat speed sensor and bore in steering knuckle With Moiykote Longterm 2. Replace O-ring of speed sensor.

9558

2. Turn off ignition, take wire plug out of holder and undip wire on rear" axle carrier.

1. Coat speed sensor and bore in steering knuckle With Moiykote Longterm 2. Replace O-ring of speed sensor.

9558

2. Insert speed sensor in steering knuckle 3. Disconnect wire plug, without application of force and mount with socket head screw. Tightening torque: 6 to 8 Nm.

4, Unclip wire in holders on wheel carrier. Unscrew socket head screw and pull speed sensor out of wheel carrier.

Installing

0 0

Post a comment