Note

— Rubber mounts on speed sensors are connected with wire covers in precise position.

— Take speed sensors out of protective packaging only briefly before installation (loss of permanent magnetism).

— Make sure that there are no foreign metal particles (burrs) on magnetic edge of speed sensor before installing.

2, Place speed sensor in wheel carrier without application of force and mount with socket head screw.

Tightening torque: 6 to 8 Nm.

3. Clip wire in holders on wheel carrier and rear axle cross member.

4. Connect wire plug and insert in holder. Mount wheel.

5. Check function with ABS tester.

1. Coat speed sensor and bore in wheel carrier with Molykote Longterm 2. Replace O-ring of speed sensor.

0 0

Post a comment