Rear axle

Height adjustment: From wheel contact area to measurement surface on cross member

Toe per wheel

Camber

10 mm may be affected only replacement by of steering arms

10 mm

* Adjustment values for wheel alignment are only valid for actual vehicle height (see Rep. Manual page 44-1).

** The height adjustment values apply to new vehicles. Used vehicles may be up to 10 mm lower, i.e. the tolerance towards „too low" may deviate by 10 mm. However, this must then be the case for both axles.

*** The caster value of 4"+1' can be set retroactively on Model '90 vehicles.

Location Thread Tightening torque

Nm(ftlb)

Fillister head screw to clamping nut

M 7

15(11)

Brake caliper to steering knuckle

M 12x 1.5

85(63)

Brake caliper to wheel carrier

M 12x1.5

85(63)

Brake disk to wheel hub

M 6

10(7)

Guard plate to steering knuckle

M 7

15(11)

Handbrake locking segment to bearing bracket

M8

25(18)

Universal shaft/

rear wheel shaft to wheel hub

M 22x1.5

460 (339

Wheel to wheel hub

M 14x 1.5

130 (96)

Locking segment to handbrake lever

M8

23(17)

Guard plate to wheel carrier

M 8 M 6

23(17) 10(7)

Speed sensor

M 6

10(7)

to wheel carrier and steering knuckle to wheel carrier and steering knuckle

0 0

Post a comment