Adjusting Clutch Spring

A spring which reduces the pedal force is installed to assist the force applied to the pedal. For this purpose, the spring must be preloaded accordingly.

Measure distance A between outer edge of plate and bearing with clutch engaged (clutch pedal at end stop).

- Distance A for green color-coded spring (no longer available as spare part) 60 mm (75 mm*)

- Distance A for blue color-coded spring (increased spring rate/in use since February 1986)

If necessary, correct by turning the hex nut.

If necessary, correct by turning the hex nut.

* Values of distance A in parentheses apply to spring when removed. Reassemble servospring/guide rod with assembly wire (3 mm dia. split pin).

JtSBs*.

Was this article helpful?

0 0

Post a comment