Disassembling And Assembling Final Drive Case Cover

1. Remove torque converter seal.

3. Press out outer race for tape red roller bearing. A - US 1037

2. Press seals out of cover. A - US 1108

1. Press in outer race for tapered roller bearing.

1. Press in outer race for tapered roller bearing.

2. Drive first seal into cover against stop. Open 4. Drive in torque converter seal.

2. Drive first seal into cover against stop. Open 4. Drive in torque converter seal.

3. Drive second seal into cover until flush. Open end of seal faces transmission. Large shoulder on mandrel serves as stop.

3. Drive in second seal until flush.

Open end of seal faces automatic transmission assembly.

4. Position seals correctly.

B - Seal - automatic transmission assembly

Was this article helpful?

0 0

Post a comment