Disassembling And Assembling Pinion

1. Press off tapered roller bearing (small bearing).

2. Press off sleeve for seals. A - US 1103

3. Press off tapered roller bearing (large bearing). A - US 1103

1. Heat large tape red roller bearing to approx. 100 °C/212 °F and install. Then press on tight.

2. Heat sleeve for seals to approx. 100 °C/212 °F and install. Then press on tight.

3. Heat small tapered roller bearing to approx. 100 °C/212 °F and install. Then press on tight.

Modifications:

Removing and installing flat governor

1 - Flat governor

2 - Sealing ring (always renew)

3 - Governor cover

Removing and installing speedometer drive

2 - Retaining plate

Disassemble speedometer drive.

2 - Pinion

3 - Bearing

4 - Sealing ring (always renew)

Lift lock (1) of pinion (2) using two screwdrivers. Remove pinion from bearing (3).

Was this article helpful?

0 0

Post a comment