Disconnecting And Connecting Automatic Transmission On Final Drive

Mount automatic transmission on assembly stand with holder VW 351 and disconnect final drive.

1 - Hole plate (made locally - sketch on page 38 3)

Check axiaI play. adjusting if necessary, after repairing final drive or automatic transmission.

3. Check length of turbine shaft. a = 424.5 mm.

4. Make sure piston rings for turbine shaft are positioned correctly.

38 - 6 Disconnecting and Connecting Automatic Transmission on Final Drive (Type 087 N)

Was this article helpful?

0 0

Post a comment