Info

7. Press on sliding sleeve with synchronizer body. Turn synchronizer ring so that grooves are aligned with locks.

6. Assemble sliding sleeve and synchronizer body for

1st and 2nd gears. It is not necessary to have a pair in a certain position. Insert locks and install springs with 120┬░offset. Spring must have its angled end engaging in hollow lock.

8. Adjust axial play on synchronizer body. Measure axial play of synchronizer body with a feeler gauge blade and correct to a value between 0 and 0.04 mm by selecting pertinent circlip. Lower value would be ideal.

Circlips available:

Part Number

Thickness (mm)

Was this article helpful?

0 0

Post a comment