Note

To drill out 8 mm shear bolt, proceed as follows:

Punch bolt off-center (steering wheel side) across cutout for steering shaft harness in bottom of instrument panel.

Pre-drill with a 4 mm dia. drill bit (min. length 120 mm) across the above aperture. Finish by drilling shear bolt from threaded bushing (pressed-in bushing) with 7-8 mm dia. drill bit (longer than 120 mm).

Porsche 100137
1095-48

6. Pull connector off ignition/starter switch and buzzer contact. Pull out steering/ignition lock.

1068-37
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment