Scope of conversion for 911 Carrera RS Bodyinwhite

Instructions for conversion of 911 Carrera 2 body-in-white to 911 Carrera RS (Base and NGT versions)

No. Operation

1 Remove bracket for lock control Base version only: Weld in bracket for ABS control unit

Instructions

Using a spotweld cutter and angle grinder, separate weld joints of lock control bracket.

MIG-weld bracket for ABS control unit to front right-hand side member, running a full seam.

Only base version:

Remove bracket for front cover. Weld in reinforcement for front closing section, trunk protection and bracket for pump cover

Using a spotweld cutter, separate spotwelds of bracket for front cover on side members. MIG-weld reinforcement for towing hook support, trunk protection and bracket for pump cover, running an intermittent full seam.

Base version only:

Weld in auxiliary battery bracket

MIG-weld a welding nut (8 mm A/F) into the reinforcement for the battery bracket.

Base version only:

Weld consoles and welded studs to side member

Weld consoles and welded studs for battery disconnecting point to side member.

Weld in bracket for intensive cleaning system

MIG-weld bracket for intensive cleaning system to wheel house, running a full seam.

Base version only:

Remove bracket for water tank

Separate top water tank bracket from left-hand front wheel house, using a spotweld cutter.

Drill holes for spring strut tower to 10 mm dia.

Drill the two spring-strut tower holes in the top side-member overlap area to 10 mm dia.

Carrera 4 Table Of Contents Main Menu

«f 1 Canera R8 Body, Center 51

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment