Removing and installing input shaft seal Removing

1. Remove engine/gearbox assembly and disconnect transmission.

2. Remove release-bearing guide tube.

3. Screw Special Tool 9251 firmly into the seal.

4. Pull out seal by screwing in the hexagon head screw.

Note

If the helical tension spring jumps out when removing the seal, pull from the input shaft using a wire hook.

911 Carrera 4 Manual Transmission, Controls, Case

Installing

1. Slide assembly sleeve 9255 over the Input 3. Drive seal into place with Special Tool 9256.

shaft gearing.

4. Install guide tube and tighten fastening 2. Fill the area between sealing lips with grease screws with 10 Nm (7.5 ft.lb.)

(e.g. Olista Longtime 3 EP)

Removing and installing input shaft seal

Printed in Germany - II, 1989

Carrera 4 Table Of Contents Carrera 2 Addendum Main Menu

911 Carrera 4 Manual Transmission, Controls, Case 34

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment