Determining installation position of drive pinion Measuring actual values

Note

Initial production vehicles used drive sets that did not have the "E" and "F" marks for service adjustment.

When replacing components that affect the drive pinion position directly on those transmissions, the actual values must be measured.

1. Remove differential.

2. Assemble measuring mandrel VW 385/1 and set to design dimension

"Ro" = 64.00 mm. (Refer to page 39 - 129).

3. Install measuring mandrel and measure difference (deviation "r") to "Ro".

4. Design dimension "Ro" plus deviation "r" equals the actual or setting dimension "E".

5. After the parts have been replaced, adjust the drive pinion, taking the actual value determined into account.

Triebsatz einstellen

Printed in Germany - XV, 1992

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment