Dismantling and assembly notes

Dismantling

1. Remove snap ring with Special Tool 9332 using a press.

i—-A

P-li

\

1 n

STB

866-38

2. To loosen, apply compressed air across the oil feed bore and take out by knocking lightly on a wooden support.

Assembly

1. Fit snap ring, placing internal section of Special Tool 9330/1 into position and pushing snap ring up to the taper. Then use outer section of Special Tool 9330/1 and a press to push the snap ring into the groove.

865-38

A = Special Tool 9330/1 B = Snap ring

2. Coat discs with ATF fluid.

0 0

Post a comment