Removing and installing keylock bowden cable Removal

1. Disconnect battery. 6. Undo mounting screws of valve body.

2. Remove complete center console, knee guard and side nozzle.

3. Undo Central Information System and leave it supended on the wiring.

4. Turn ignition lock to position „2" (Ignition on). Note

The ignition lock must be in position „2". If it is left in any other position, both the lock and the bowden cable may be damaged.

5. Unbolt bowden cable from ignition lock.

5. Unbolt bowden cable from ignition lock.

1068-3/
Porsche 911 Ignition Wiring

7. Disengage bowden cable from pedal floorboard and from bracket for center console.

Installation

1. Assemble in reverse order, observing the following points.

2. Turn ignition lock to position „2" (Ignition on) and fit bowden cable to ignition lock. Tightening torque: 2.5 Nm (2 ftlb)

3. Fit bowden cable valve body using sleeves and hexagon head bolts.

Tightening torque: 2.5 Nm (2 ftlb)

4. Set selector lever to position ,,P" and turn ignition lock to position „0".

Note

If the ignition lock cannot be turned to the 0 position, the bowden cable must be readjusted.

5. Adjust bowden cable, turning the cable sleeve on the valve body until the lock slide reaches a setting of 2 + 0.5 mm (refer to Fig.).

Porsche 911 Valve Adjustment
A = 2 + 0.5 mm

6. Check operation of keylock and shiftlock.

911 Carrera 2 Automatic Transmission - Operation, Housing

0 0

Post a comment