Sealing off the driving shaft

1. Drain ATF

2. Remove engine with gearbox (do not unbolt engine from gearbox.

3. Remove intermediate plate (see page 37 - 107).

4. Remove bearing cap with Torx insert T 27 and replace rotary shaft seal. Pack space between dust lip and sealing lip with grease (e.g. Shell 8420).

A = Rotary shaft seal 422-39

5. Fit bearing cap with new O-ring and tighten fixing screws with 10 Nm.

6. Remove snap ring for bearing cap at intermediate plate and pull out cap.

A = Snap ring B = Rotary shaft seal

7. Replace rotary shaft seal.

Pack space between dust lip and sealing lip with grease (e.g. Shell 8420). Press-in depth 2.0 ± 0.5 mm

8. Fit new O-ring and wet with ATF.

9. Insert bearing cap and fit snap ring.

10. Fill with ATF.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment