Adjusting Keylock bowden cable


If the ignition lock cannot be turned to the „0" position with the selector lever set to ,,P", the bowden cable position should be corrected as follows:

1. Set selector lever to "P" position. Set ignition lock to „II" position and turn to "0" again.

2. To adjust cable, turn the cable sleeve at the slide housing (No. 1) until the distance (A) between the notch at the locking slide (No. 2) and the mark edge of the gate (No. 3) is 6 mm.

When turning the sleeve, lock at the square of the slide housing (No. 4) to keep it from turning.

A = 6 mm

3. Check operation of Keylock and Shiftiock.

Was this article helpful?

0 0
Porsche Classic Models

Porsche Classic Models

The History of Porsche Cars through its generational changes. A must have ebook for any Porsche fanatic, this ebook is a reference book for Porsche enthusiasts. Discover all there is to know about the greatest Porsches ever made. All models are fully described and illustrated providing a definitive production history plus an accurate guide to original specs and equipment.

Get My Free Ebook

Post a comment