Fitting toothed belt for balance shaft Note

Handle balance shaft toothed belt with care, avoid twisting or turning as this may cause excessive running noise. Store separately.

When replacing the toothed belt, do not undo the mounting bolts of the balance shaft drive sprockets.

1. Rotate crankshaft clockwise until the TDC mark on the camshaft drive sprocket lines up with the mark on the toothed belt cover. The TDC mark on the flywheel (center notch of double-mass flywheel) must also line up.

2. Rotate both balance shafts (without toothed belts) until the marks on the balance shaft drive sprockets are lined up with the marks on the rear toothed belt cover.

Porsche Tdc 968 Markings Figure 794Porsche Tdc 968 Markings Figure 794

3. Fit the toothed belt:

When fitting the toothed belt, make sure the belt side with the color-coded tooth faces towards the outside.

4. Adjust toothed belt tension according to specification.

Fitting toothed belt for balance shaft

Printed in Germany - IV, 1992

Was this article helpful?

0 0
Porsche Classic Models

Porsche Classic Models

The History of Porsche Cars through its generational changes. A must have ebook for any Porsche fanatic, this ebook is a reference book for Porsche enthusiasts. Discover all there is to know about the greatest Porsches ever made. All models are fully described and illustrated providing a definitive production history plus an accurate guide to original specs and equipment.

Get My Free Ebook

Post a comment