Removing and installing drive pinion and drive shaft

Removing Snap Ring From Rear Axle

No.

Designation

Removal

Installation

1

Shift catch (light)

4

Do not confuse with catch No. 1 on page 34 - 5. Tighten to 70 Nm (52 ftlb)

2

Snap ring

1

3

Driver (1 st and 2nd gear)

1

4

Shift rod (5th and 6th gear)

1

Replace only as a unit with driver for 5th and 6th gears (also refer to page 34-12)

5

Reverse driver

1

Cutout must engage into reverse gear return lever

6

Snap ring

1

7

Cylinder roller bearing inner-race

1

Pull off manually

8

Drive shaft

1

Take out along with shift rod (No. 9)

9

Shift rod (3rd and 4th gear) with shift lever

1

Replace only as a unit with driver for 3rd and 4th gear

10

Snap ring

1

Note thickness for reinstallation

If required, redetermine thickness (refer to page 34 - 17)

11

6th gear fixed gearwheel

1

Replacement is only possible if end shield has been removed. Press off using a suitable shop press

Heat to approx. 120°C and press on to stop using a shop press Installation position: Flange must face tapered roller bearing

12

Drive pinion

1

13

Shift rod (1st and 2nd gear)

1

Replace only complete with pin-locked shift fork

14

End shield

1

Porsche Classic Models

Porsche Classic Models

The History of Porsche Cars through its generational changes. A must have ebook for any Porsche fanatic, this ebook is a reference book for Porsche enthusiasts. Discover all there is to know about the greatest Porsches ever made. All models are fully described and illustrated providing a definitive production history plus an accurate guide to original specs and equipment.

Get My Free Ebook


Responses

  • rhonda
    How to replace ring pinion 968?
    6 years ago

Post a comment