Printed in Germany - VII, 1992
- Selector shaft must be set to ,,N". To achieve this, turn shaft in opposite direction of the direction of travel up to the stop (position ,,P"). Then shift selector shaft back two notches into position ,,N".
- Place Special Tool 9342 onto selector shaft and turn switch until the hole in the Special Tool lines up with the adjustment hole in the switch. Locate installation position of the switch in this position, using the pin.
A = Locating pin B = Fastening screws C = Special Tool 9342
- Tighten fastening screws of switch to specified torque and take off Special Tool with locating pin.
4. Recheck adjustment of selector lever cable and correct if required (refer to page 37 -213)
Was this article helpful?
The History of Porsche Cars through its generational changes. A must have ebook for any Porsche fanatic, this ebook is a reference book for Porsche enthusiasts. Discover all there is to know about the greatest Porsches ever made. All models are fully described and illustrated providing a definitive production history plus an accurate guide to original specs and equipment.