Adjusting Keylock bowden cable

Note

If the ignition lock cannot be turned to the „0" position with the selector lever set to ,,P", the bowden cable position should be corrected as follows:

1. Set selector lever to "P" position. Set ignition lock to „II" position and turn to "0" again.

2. To adjust cable, turn the cable sleeve at the slide housing (No. 1) until the distance (A) between the notch at the locking slide (No. 2) and the mark edge of the gate (No. 3) is 6 mm.

When turning the sleeve, lock at the square of the slide housing (No. 4) to keep it from turning.

A = 6 mm

3. Check operation of Keylock and Shiftlock.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment