Adjusting lift solenoid of Shiftlock

Adjust lift solenoid as follows:

— After fitting the lift solenoid, push it all the way down in the slots of the gate guide (No. 5). Tighten fastening screws (No. 3) only lightly.

— Fit the angular lever (No. 2) to the gate guide (No. 5) using the 8 mm stud (assembly tool/No. 1).

— Apply current to lift solenoid (apply system voltage, observe correct polarity) and slide along inside slots until the locking idler lightly touches the surfaces a and b of the ratchet (No. 4).

— Tighten fastening screws (No. 3) to 2.8 Nm (2 ftlb) in this position. Check operation again.

2

1282-37

Was this article helpful?

0 0
Porsche Classic Models

Porsche Classic Models

The History of Porsche Cars through its generational changes. A must have ebook for any Porsche fanatic, this ebook is a reference book for Porsche enthusiasts. Discover all there is to know about the greatest Porsches ever made. All models are fully described and illustrated providing a definitive production history plus an accurate guide to original specs and equipment.

Get My Free Ebook


Post a comment