Installation Note

The cylinder head may be fitted with the engine remaining in the car.

1. Place cylinder head gasket into correct position.

2. Fit cylinder head. Tightening sequence:

3. Replace gaskets, seals and O-rings before fitting the cylinder head. Tighten nuts and bolts to the specified torque.

4. Top up coolant and bleed cooling system. Warm up engine to operating temperature, check coolant level again and top up if required.

271-15

For unbolting, follow opposite sequence.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment