Note

When the solenoids are removed and fitted, the control unit may remain installed.

To replace solenoids 1, 2 and 3, however, the solenoid housing (1) must be removed.

The installation position of solenoid 4 is shown on page 38-211.

2. Pull connector sleeves off the solenoids.

3. Screw out fastening screws and and take off valve housing complete with valves. (Transmission is removed in figure)

1273-38

A =

Bolt

M

6

X

80

B =

Bolt

M

5

X

70

C =

Bolt

M

5

X

65

4. Mark installation position of solenoids for reassembly, remove retaining brackets and take out solenoids.

1274-38

E = Solenoid for pressure regulator 1 = Solenoid housing

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment