Note

Do not leave control unit suspended at wiring harness.

5. Install control unit in such a manner that the pin of the detent disc engages in the cutout of the selector slide.

A = Screw length 80 mm B = Screw length 70 mm C = Screw length 27 mm

6. Tighten fastening screws to specified torque.

1267-38

A = Screw length 80 mm B = Screw length 70 mm C = Screw length 27 mm

7. Fit ATF filter complete with sealing ring and tighten fastening screws to specified torque.

8. Connect wiring harness to transmission socket, engaging connector carefully into socket (fits only in one position) and locking it by turning the bayonet lock to the right.

1259-38

9. Place solenoid in round groove to ATF pan, place gasket into position and tighten pan using the retaining brackets.

10. Fit bleeder hoses to reservoir.

11. Fit ATF drain plug with new seal and tighten to specified torque.

1267-38

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment