Removal and installation notes

Removal

Note

When working on the gear set, it is not necessary to remove the differential.

1. Clamp transmission with Special Tool VW 540 into assembly stand and drain transmission oil.

Installation Note

To avoid damaging the seal, install drive shaft seal only after the gear set has been installed.

1. Coat end shield/transmission housing sealing surface with sealant (Loctite 573) and place full gear set carefully into transmission housing.

2. Drive adapter sleeves into position and tighten mounting screws to 25 Nm (18 ftlb)

3. Fit seal for drive shaft (refer to page 34 - 7).

1152-34
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment