Removing and installing doublemass flywheel and grooved bail bearing

Removal

1. Fit double-mass flywheel to engine support adapter using Special Tool 9538/1.

2. Unbolt clutch pressure plate evenly and take off pressure plate complete with drive plate.

3. Undo cylinder bolt (multi-tooth bolt) from double-mass flywheel and lift off. Caution! Take care not to damage the reference mark sender.

Installation

Tighten cylinder bolts in two steps.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment