Removing and installing drive pinion and drive shaft

No

Designation

Removal

Installation

1

Shift catch (light)

4

Do not confuse with catch No. 1 on page 34 - 5. Tighten to 70 Nm (52 ftlb)

2

Snap ring

1

3

Driver (1 st and 2nd gear)

1

4

Shift rod (5th and 6th gear)

1

Replace only as a unit with driver for 5th and 6th gears (also refer to page 34-12)

5

Reverse driver

1

Cutout must engage into reverse gear return lever

6

Snap ring

1

7

Cylinder roller bearing inner-race

1

Pull off manually

8

Drive shaft

1

Take out along with shift rod (No. 9)

9

Shift rod (3rd and 4th gear) with shift lever

1

Replace only as a unit with driver for 3rd and 4th gear

10

Snap ring

1

Note thickness for reinstallation

If required, redetermine thickness (refer to page 34 - 17)

11

6th gear fixed gearwheel

1

Replacement is only possible if end shield has been removed. Press off using a suitable shop press

Heat to approx. 120°C and press on to stop using a shop press Installation position: Flange must face tapered roller bearing

12

Drive pinion

1

13

Shift rod (1st and 2nd gear)

1

Replace only complete with pin-locked shift fork

14

End shield

1

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment