Removing and installing knock sensor

1. To remove and install the knock sensors, unbolt the intake rail from the engine. Refer to page 15-21 to 15-22.

The coolant hoses remain connected. The intake rail remains in the engine compartment.

2. Undo and take out knock sensors. Disconnect connector.

3. Reinstall with a new genuine M 8 x 30 bolt (micro-sealed) without washer.

Tightening torque: 20 Nm (15 ftlb.) Note

Handle the knock sensor very carefully. The knock sensor must never drop to the ground from greater heights as this may damage the piezocrystal.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment