Removing and installing oil restraining valve

1 - Threaded pin

2 - Spring guide

4 - Thrust spring

1. Remove cylinder head cover. Screw one hexagon head bolt, e.g. M 6 x 40, into spring guide from above. Undo threaded pin by two turns and pull out spring guide in upward direction.

2. Take out thrust spring and ball using a magnet. Clean ball seat, ball, thrust spring and oil duct thoroughly. The ball seat remains in cylinder head and must not be damaged.

3. Replace O-ring before fitting and oil lightly. Tightening torque for threaded pin:

31-17

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment